3Com 3CRUS2475 - Page 63

Modifying Multiple Hosts 63
To modify Multiple Hosts:
1 Click Policy > Security > Multiple Host > Modify. The Multiple Host
Modify Page opens:
Figure 34 Multiple Host Modify Page
The Multiple Host Modify Page contains the following fields:
■ Port — Displays the port number for which advanced port-based
authentication is enabled.
■ Enable Multiple Hosts — Indicates whether multiple hosts are
enabled. Multiple hosts must be enabled in order to either disable the
ingress-filter, or to use port-lock security on the selected port. The
possible field values are:
■ Multiple — Multiple hosts are enabled.
■ Disable— Multiple hosts are disabled.
■ Action on Violation — Defines the action to be applied to packets
arriving in single-host mode, from a host whose MAC address is not
the supplicant MAC address. The possible field values are:
■ Forward — Forwards the packet.
■ Discard — Discards the packets. This is the default value.
■ Shutdown — Discards the packets and shuts down the port. The
port remains shut down until reactivated, or until the device is
reset.