ABB ACS6000 - Removing an Air-To-Air Heat Exchanger; Tools for Removing an Air-To-Air Heat Exchanger

05 MECHANICAL INSTALLATION
3BHS212794 E01 REV M ACS6000 USER MANUAL 118/278
Depending on the drive configuration, at least one heat exchanger must
be removed for joining the DC busbars of two adjacent transport units.
Figure 5-15 Tools for removing an air-to-air heat exchanger
5.8.2.1 Removing an air-to-air heat exchanger
1. Loosen the 4 self-tapping M6x12 screws (HAQN401205P0257) that
fasten the heat exchanger to the roof.
2. Remove the cable ties.
(1) Cordless drill
(2) Wire cutter
(3) Torx drill bit
(4) Cable tie
1
2
3 4