ABB ACS6000 - Changing a Parameter Setting

3BHS212794 E01 REV M ACS6000 USER MANUAL 211/278
09 CDP CONTROL PANEL
9.2.3.2 Changing a parameter setting
1. To enter the parameters mode, press the PAR key.
2. To select a different group, press a fast navigation key.
3. To select a parameter, press a slow navigation key.
4. To enter the parameter setting function, press the ENTER key.
1 L -> 600.0 rpm
77 SYSTEM CONFIG
01 INU IdentifySel
INU1 (MASTER)
ACT PAR FUNC DRIVE
LOC
I0
RESET REF
ENTER
REM
1 L -> 600.0 rpm
75 OPTION MODULES
06 C3P1/AI820 Module
DISABLED
ACT PAR FUNC DRIVE
LOC
I0
RESET REF
ENTER
REM
1 L -> 600.0 rpm
75 OPTION MODULES
07 C3P1/AI820 Module
DISABLED
ACT PAR FUNC DRIVE
LOC
I0
RESET REF
ENTER
REM
1 L -> 600.0 rpm
75 OPTION MODULES
07 C3P1/AI820 Module
[DISABLED]
ACT PAR FUNC DRIVE
LOC
I0
RESET REF
ENTER
REM