05 MECHANICAL INSTALLATION
3BHS212794 E01 REV M ACS6000 USER MANUAL 96/278
5.3 General notes on installation
5.3.1 Dimensions and clearances
For information on dimensions, location and size of fixing holes and
clearances, see “Appendix C – Mechanical drawings”.
5.3.2 Access to the cabinets
Joining transport units and fitting the DC- busbar joints require rear and
top access.
5.3.3 Cabinet roof
5.3.4 Fire protection
▲NOTICE
Risk of component damage!
Observe the following during installation:
• Ensure that no dirt enters the drive. Always close the doors when
work is discontinued and completely cover openings. Metallic dust
in particular could cause failures when the drive is powered up and
cause damage.
• When joining two transport units, do not damage or dislocate the
EMC sealing strip that is glued onto the outer joining surfaces of
the cabinet frame.
• If the transport units are joined but not yet on the base frame, do
not lift and move them with a crane. Instead, use appropriate
transport means, such as heavy load hydraulics rollers or
air cushions.
▲NOTICE
Risk of damage.
The cabinet roof is not designed as a base for foreign devices or
cable ducts.
• DO NOT install any foreign objects on the roof and do not step
on roof.
⚠ CAUTION
• To prevent fire from spreading into the drive, apply suitable fire
protection measures.
To Next Page
Loading...
