ABB ACS6000 - Installation Example of Pressure Relief Vents; Tools Required to Fasten the Pressure Relief Vent to the Roof

05 MECHANICAL INSTALLATION
3BHS212794 E01 REV M ACS6000 USER MANUAL 122/278
Figure 5-19 Tools required to fasten the pressure relief vent to the roof
Procedure
1. Orientate the pressure relief vents with the baffle blades (arrows)
pointing to the center of the drive.
Note: The orientation of the baffle blades can be seen through the grille on
the underside.
Figure 5-20 Installation example of pressure relief vents
2. Fasten the pressure relief vent to the roof with the supplied
screws (Fig. 5-20).
(1) Cordless drill
(2) Torx bit
(3) 24 x M6x20 Self-tapping
(HAQN40105P0260)
(1) Orientation of baffle blades
(2) Center of drive
(3) Pressure relief vents
1
2
3
1
1
2
3
3