05 MECHANICAL INSTALLATION
3BHS212794 E01 REV M ACS6000 USER MANUAL 98/278
5.4 Aligning transport units
This section applies to drives that are delivered in several transport units.
1. If a transport unit has water pipes, remove the protective covers from
the water pipe ends on both sides.
2. Check that a pipe joint (1) has been slid on one pipe end of two
adjoining water pipes.
3. Line-up the transport units as shown in “Appendix C – Mechanical
drawings”.
Note: The units can be lined-up either beginning from the left or
the right.
1
To Next Page
Loading...
