04 TRANSPORTATION, STORAGE AND DISPOSAL
3BHS212794 E01 REV M ACS6000 USER MANUAL 90/278
4.5.1.1 Lifting recommendations
Refer to Fig. 4-1 and Fig. 4-2 when following these ABB recommendations:
• Use a lift frame or a lift spreader with the crane.
• Use lifting equipment (eg, web slings, chain slings, round slings,
safety hooks, shackles) that corresponds to the weight that is to
be lifted.
• Attach the slings to the lifting brackets at the base frame.
• To attach the slings, screw an eye bolt (not supplied) into each of
the four corners of the cabinet roof
• Use appropriate safety hooks or shackles to attach a sling.
• DO NOT pass a sling through the hole of the bracket.
• Protect the edges and the door handles if the slings are too close to
the cabinet.
• If a lift frame or lift spreader is not available, make sure that the
slope angle is a maximum of 15° (see Fig. 4-2).
• Observe the center of gravity
• Lift the drive or a transport unit slowly and steadily to the required
clearance height, maintaining it in upright position.
• Check the horizontal position and reposition the slings if necessary.
Figure 4-1 Lifting bracket (1) on base frame of a drive, safety hook (2) secured
to lifting bracket and eye bolt (3).
(1) Lifting bracket (hole ∅42 mm)
(2) Safety hook
(3) Eye bolt
1
2
To Next Page
Loading...
