3BHS212794 E01 REV M ACS6000 USER MANUAL 179/278
08 OPERATION
8.5.1 Operational settings
Note: The control panel is only used if an alarm or a fault condition must
be rectified.
After commissioning of the EXU, the control panel is set to remote, and
local operation is locked in parameter 16.04 LocLock
. This setting
prevents the control panel being switched to local control unintentionally.
The actual values shown on the display can be freely selected. The
following default values are shown on the display when the panel is in
local mode:
• Motor current in %
• Actual armature voltage in V
• Actual converter current in A (rectified AC current value)
When the control panel has been set to remote, the START / STOP keys
become inoperable.
8.5.2 Resetting alarm and fault messages
• Alarm messages: cannot be reset by pressing the reset soft key.
The alarm resets automatically as soon as the reason causing the
alarm has been resolved.
• Fault messages: must be reset manually after the reason causing the
fault has been resolved.
The message on the display can be reset either by pressing the reset
soft key on the EXU control panel, or by pressing the reset button
on the control panel of the drive.
8.5.3 Parameter settings
The parameters are set as required for operation and verified during
commissioning and must not be changed afterwards.
▲NOTICE
Risk of component damage!
DO NOT unlock local operation and switch the control panel to remote
while the drive is in operation!
• If you attempt to perform these actions, the drive shuts down
▲NOTICE
Risk of component damage!
Running the drive system with incorrect data can result in improper
operation, reduction of control accuracy and damage of equipment!
• DO NOT change any parameter if the meaning of the parameter and
the effects of the change are not fully understood.
To Next Page
Loading...
