10 PREVENTIVE AND CORRECTIVE MAINTENANCE
3BHS212794 E01 REV M ACS6000 USER MANUAL 222/278
10.2 Identifying electrical equipment
This section describes how to identify electrical devices, cables,
and wires.
10.2.1 Device designation
To facilitate the identification in wiring diagrams and parts lists, all
devices are labeled in accordance with IEC 81346-1.
Figure 10-1 Device identification
10.2.2 Cables and wires
Cables and wires in the drive are equipped with marker sleeves that carry
the same identifying number as on the wiring diagrams.
Figure 10-2 Cable and wire designation
–A1421
PP C907AE 275MHz
AMC34–BOARD
CDP312_ARU
141.F2
X17
R P T2 S1 S0
RX
TX
INTO
F M T1 S3 S2
DSP56311
RS485
6
PANEL & BUS
INTERFACE
(1) Wire number (2) Terminal number
1
2
To Next Page
Loading...
