ABB ACS6000 - Operational Commands; Setting the Direction of Rotation

09 CDP CONTROL PANEL
3BHS212794 E01 REV M ACS6000 USER MANUAL 218/278
Note: To prevent accidental switching from remote control to local
control, see “9.2.5.2 Disabling / enabling local lock function” on page 216.
9.3 Operational commands
For instructions on how to start and stop the drive system from the
control panel, see “8.9 Starting the drive” on page 189 and “8.10 Stopping
the drive” on page 193.
9.3.1 Setting the direction of rotation
Setting the direction of rotation from the CDP control panel is possible in:
• Local control mode (L)
• Remote control mode (R)
The arrow on the display indicates the direction of rotation:
• When the motor is running, the arrow indicates the actual direction.
• When the motor is not running, the arrow indicates the preselected
direction.
To set the direction of rotation, press the forward or backward key.
1 R 600.0 rpm 0
StateINU ReadyRun
MOTOR SP 0.00 rpm
POWER 0.0 kW
1 L -> 600.0 rpm
StateINU ReadyRun
MOTOR SP 600.00 rpm
POWER 75.0 kW
ACT PAR FUNC DRIVE
LOC
I0
RESET REF
ENTER
REM