Figure 5-4 Top view of DC busbar configuration 1 104
Figure 5-5 Top view DC busbar configurations 2 (A), 3 (B)
and 4 (C) 105
Figure 5-6 Ground busbar joints 106
Figure 5-7 AC busbar joints between the COU/TEU and LSU
(5/7/9 MVA). 107
Figure 5-8 AC busbar joints between the COU/TEU and LSU
(14 MVA). 108
Figure 5-9 Air-to-air heat exchanger (type LT-5-5165-UL) 112
Figure 5-10 Tools for installing an air-to-air heat exchanger 112
Figure 5-11 Correct and incorrect cable installation 114
Figure 5-12 ARU/INU/IFU cable routing 116
Figure 5-13 LSU cable routing 116
Figure 5-14 Air-to-air heat exchangers (type LT-5-5165-UL) 117
Figure 5-15 Tools for removing an air-to-air heat exchanger 118
Figure 5-16 Installation example of transformers in an air-to-air
heat exchanger 120
Figure 5-17 Connect wires to terminal block 121
Figure 5-18 Pressure relief vents 121
Figure 5-19 Tools required to fasten the pressure relief vent
to the roof 122
Figure 5-20 Installation example of pressure relief vents 122
Figure 5-21 Attach sealing tape to the joining crossbar (1) 123
Figure 5-22 Roof joints (1) 124
Figure 5-23 Roof attachment parts 125
Figure 5-24 Recommended ceiling and wall fixings 126
Figure 6-1 Phase module on lift table 127
Figure 6-2 Grounding the input side (A) and output side (B)
of the drive system 129
Figure 6-3 System ground connection (1) in a 600 mm TEU 130
To Next Page
Loading...
