ABB ACS880 - Page 138

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = 1 % / 1 = 1 %Flux reference.0...200 %
0.00 / real32Momentary cosphi of the drive.INU momentary cos φ1.25
100 = 1 / 100 = 1Cosphi.-1.00 ... 1.00
- / real32Rate of actual speed change. Positive values indicate
acceleration, negative values indicate deceleration.
See also parameters 31.32 Emergency ramp supervision,
31.33 Emergency ramp supervision delay, 31.37 Ramp
stop supervision and 31.38 Ramp stop supervision delay.
Speed change rate1.29
1 = 1 rpm/s / 1 = 1
rpm/s
Rate of speed change.-15000...15000 rpm/s
0.000 Nm or lb·ft /
uint32
Torque that corresponds to 100% of nominal motor torque.
The unit is selected by parameter 96.16 Unit selection.
Note: This value is copied from parameter 99.12 Motor
nominal torque if entered. Otherwise the value is calculated
from other motor data.
Nominal torque scale1.30
1 = 1 Nm or lb·ft / 1000
= 1 Nm or lb·ft
Nominal torque.0.000 ... 4000000.000
Nm or lb·ft
- / real32Measured temperature of incoming cooling air. The unit
(°C or °F) is selected by parameter 96.16 Unit selection.
Ambient temperature1.31
1 = 1 ° / 10 = 1 °Cooling air temperature.-40.0 ... 200.0 °
- / int16Amount of energy that has passed through the drive
(towards the supply) in full gigawatt-hours. The minimum
value is zero.
Inverter GWh
regenerating
1.32
1 = 1 GWh / 1 = 1
GWh
Regenerative energy in GWh.0...32767 GWh
- / int16Amount of energy that has passed through the drive
(towards the supply) in full megawatt-hours. Whenever the
counter rolls over, 1.32 Inverter GWh regenerating is
incremented. The minimum value is zero.
Inverter MWh
regenerating
1.33
1 = 1 MWh / 1 = 1
MWh
Regenerative energy in MWh.0...1000 MWh
- / real32Amount of energy that has passed through the drive
(towards the supply) in full kilowatt-hours. Whenever the
counter rolls over, 1.33 Inverter MWh regenerating is
incremented. The minimum value is zero.
Inverter kWh
regenerating
1.34
10 = 1 kWh / 1 = 1
kWh
Regenerative energy in kWh.0...1000 kWh
0 GWh / int16Amount of net energy (motoring energy - regenerating
energy) that has passed through the drive in full gigawatt
hours.
You can reset the value by setting it to zero. Resetting any
of the parameters 1.35 to 1.37 resets all.
Mot - regen energy
GWh (resettable)
1.35
1 = 1 GWh / 1 = 1
GWh
Energy balance in GWh.-32768...32767 GWh
138 Parameters