ABB ACS880 - Page 530

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / real32Defines the nominal motor power. The setting must match
the value on the rating plate of the motor. If nominal power
is not shown on the rating plate, nominal torque can be
entered instead in parameter 99.12.
If multiple motors are connected to the drive, enter the total
power of the motors.
The unit is selected by parameter 96.16 Unit selection.
Note: This parameter cannot be changed while the drive
is running.
Motor nominal power99.10
1 = 1 kW or hp / 100 =
1 kW or hp
Nominal power of the motor.0.00 ... 10000.00 kW
or hp
0.00 / real32Defines the cosphi of the motor for a more accurate motor
model. The value is not obligatory, but is useful with an
asynchronous motor, especially when performing a
standstill identification run. With a permanent magnet or
synchronous reluctance motor, this value is not needed.
Note: Do not enter an estimated value. If you do not know
the exact value, leave the parameter at zero.
Note: This parameter cannot be changed while the drive
is running.
Motor nominal cos φ99.11
100 = 1 / 100 = 1Cosphi of the motor.0.00 ... 1.00
0.000 Nm or lb·ft /
uint32
Defines the nominal motor shaft torque. This value can be
given instead of nominal power (99.10) if shown on the
rating plate of the motor.
The unit is selected by parameter 96.16 Unit selection.
Note: This setting is an alternative to the nominal power
value (99.10). If both are entered, 99.12 takes priority.
Note: This parameter cannot be changed while the drive
is running.
Motor nominal torque99.12
1 = 1 Nm or lb·ft / 1000
= 1 Nm or lb·ft
Nominal motor torque.0.000 ... 4000000.000
Nm or lb·ft
530 Parameters