ABB ACS880 - Page 501

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
0DC switch monitoring through the DIIL input disabled.Disable
1DC switch monitoring through the DIIL input enabled.Enable
Enable / uint16
(Only visible with a BCU control unit)
Activates communication to a BSFC charging controller.
This setting is intended for use with inverter modules that
are connected to a DC bus through a DC switch/charging
circuit controlled by a charging controller. On units without
a DC switch, this parameter should be set to Disable.
The charging controller monitors the charging of the inverter
unit, and sends an enable command when the charging
has finished (ie. DC switch is closed after the 'charging
OK' lamp lights, and charging switch opened).
For more information, see BSFC documentation.
Switch fuse controller95.9
0Communication with BSFC disabled.Disable
1Communication with BSFC enabled.Enable
- / uint16
(Only visible with BCU control unit)
Specifies which converter modules have been removed
from the converter configuration. A value other than 0
activates the reduced run function.
See section Reduced run function (page 105).
Reduced run mask95.12
Module 1 has been removed.Module 1 removedb0
Module 2 has been removed.Module 2 removedb1
Module 3 has been removed.Module 3 removedb2
Module 4 has been removed.Module 4 removedb3
Module 5 has been removed.Module 5 removedb4
Module 6 has been removed.Module 6 removedb5
Module 7 has been removed.Module 7 removedb6
Module 8 has been removed.Module 8 removedb7
Module 9 has been removed.Module 9 removedb8
Module 10 has been removed.Module 10 removedb9
Module 11 has been removed.Module 11 removedb10
Module 12 has been removed.Module 12 removedb11
Reservedb12…15
1 = 10000h…FFFFh
Parameters 501