3. If the Y-piece port and breathing bag
arm connector are not occluded, the
interface after the test is shown as the
picture on the right.
During the 60s count, time proceeds with
the procedures according to the
instructions on the user interface. Or the
system will enter into the Standby
interface automatically after 60s.
Select “Skip” and the system will enter
into the Standby interface.
4. There is no operation of pushing “O
2
+”
to fulfill the bellows during the first 60s
count time after the manual test interface
appears, the interface on the right follows.
Select “Skip”, the system will enter into
Standby interface.
5.Manual test succeeds
After the manual test succeeds, the
interface displays as shown on the right.
The system will enter into Standby mode
automatically after 5s count time.
To Next Page
Loading...