8210-00020 R1 143
2. Route the throttle harness along the conveyor tube towards the gas drive.
3. Attach the throttle harness to the throttle actuator.
Figure 83. Throttle Actuator
4. Attach the throttle mounting bracket to the back guard brace of the motor mount cage. Ensure the actuator
bracket faces the spout end of the conveyor.
5. Attach the actuator to the mounting bracket with four bolts.
6. Turn on power. Using control box, extend the throttle cable to maximum extension by pressing the “Down”
throttle button until the cable is fully extended and stops moving.
7. Loosen the bolt on the throttle cable clamp. Ensure the throttle cable is at maximum extension.
8. Position the throttle cable in the clamp with approximately 1/4" of the throttle cable sleeve extending past
the clamp.
FIELD LOADER S-DRIVE – PORTABLE GRAIN BELT CONVEYOR 3. ASSEMBLY
To Next Page
Loading...
