38 8210-00020 R1
Install the Weather Guards on the Tube Brackets
Assembly Notes:
• Install the types of weather guard sections as shown on your particular conveyor model.
Important
Overlap the adjacent weather guard sections and align the holes as shown in the figure.
• Connect each weather guard section to the tube brackets using a uni-mount plate cast, 3/8" x 1-1/4" cap
screw, and 3/8" lock nut. Leave the 3/8" lock nuts loose. (See Install the Weather Guards on the Tube
Brackets on page 38.)
• Confirm all weather guard mount bar holes are aligned.
• Tighten the 3/8" lock nuts after all of the weather guards have been installed.
A
Uni-Mount Plate Cast
2
3/8" Nylon Lock Nut (GR8)
1
3/8" x 1-1/4" Flat Head Socket Cap Screw
1
A
2
IMPORTANT:
IMPORTANT:
IMPORTANT:
Align holes
Bevelled edge orientation
Proper overlap
Belt travel direction
Belt travel direction through weather guards
Spout
Hopper
3. ASSEMBLY FIELD LOADER S-DRIVE – PORTABLE GRAIN BELT CONVEYOR
To Next Page
Loading...
