8-22 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
38 Buffer overflowed. Aborted.
39 Syntax error. Undisplayable character.
40 Illegal setup. One unit assigned several CH.
41 Illegal disk. Revision mismatch.
42 Read error occurred.
43 File name is not LIF type.
44 File name is not DOS type.
45 File name is not LIF/DOS type.
46 Volume label is not LIF type.
47 Volume label is not DOS type.
48 Incorrect memory number.
49 Source and Target are same.
50 Unable to copy. Memory full.
51 Unable to copy. SRC and TGT mem num is same.
You cannot specify same memory number in both SOURCE and
TARGET name fields.
52 Illegal suffix.
53 System busy. Emergency handling.
54 System busy. Measuring.
55 System busy. Executing cal/diag.
56 System busy. Executing auto calibration.
57 System busy. Printing out hard copy.
58 Unable to copy 4145 data file to memory.
59 Unable to graph plot. Recover error state.
Unable to print out or plot out when error message is displayed.
60 Cal/diag must be performed in the idle state.
Calibration and Diagnostics cannot be performed unless the
4155B/4156B is in the idle state. For example, this error is displayed if
the SCPI calibration command is sent when the 4155B/4156B is not in
the idle state.
To Next Page
Loading...
Need help?
General
