Agilent Technologies InfiniiVision 3000 X-Series - Page 7

Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 7
For reference information, see: • Chapter 22, “Reference,” starting on page 331
When using licensed serial bus
triggering and decode features, see:
• Chapter 23, “CAN/LIN Triggering and Serial Decode,”
starting on page 351
• Chapter 24, “FlexRay Triggering and Serial Decode,”
starting on page 367
• Chapter 25, “I2C/SPI Triggering and Serial Decode,”
starting on page 377
• Chapter 26, “I2S Triggering and Serial Decode,”
starting on page 397
• Chapter 27, “MIL-STD-1553/ARINC 429 Triggering and
Serial Decode,” starting on page 407
• Chapter 28, “UART/RS232 Triggering and Serial
Decode,” starting on page 423
TIP
Abbreviated instructions for pressing a series of keys and softkeys
Instructions for pressing a series of keys are written in an abbreviated manner. Instructions
for pressing [Key1], then pressing Softkey2, then pressing Softkey3 are abbreviated as
follows:
Press [Key1]> Softkey2 > Softkey3.
The keys may be a front panel [Key] or a Softkey. Softkeys are the six keys located directly
below the oscilloscope display.