Agilent Technologies InfiniiVision 3000 X-Series User Manual

Triggers 10
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 177
As you press the D+ or D– softkey (or rotate the Entry knob), the D+
and D– label for the source channel is automatically set and the
channel you select is shown in the upper- right corner of the display
next to "USB".
If you have connected the oscilloscope's analog source channels to the
D+ and D- signals: Adjust the trigger level for each connected analog
channel to the middle of the waveform by pressing the D+ or D- softkey,
then turning the Trigger Level knob.
If you have connected the oscilloscope's digital source channels to the
D+ and D- signals (this applies to MSO model oscilloscopes only): Press
the [Digital] key and select Thresholds to set an appropriate threshold
level for the digital channels.
The value of the trigger level or digital threshold is displayed in the
upper- right corner of the display.
Serial Trigger
With serial decode option licenses (see "Serial Decode Options" on
page 125), you can enable serial trigger types. To set up these triggers,
see:
• "ARINC 429 Triggering" on page 415
• "CAN Triggering" on page 353
• "FlexRay Triggering" on page 368
• "I2C Triggering" on page 378
• "I2S Triggering" on page 400
• "LIN Triggering" on page 361
• "MIL- STD-1553 Triggering" on page 409
• "SPI Triggering" on page 389
• "UART/RS232 Triggering" on page 425

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English