Agilent Technologies InfiniiVision 3000 X-Series User Manual

351
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
23
CAN/LIN Triggering and Serial Decode
Setup for CAN Signals 351
CAN Triggering 353
CAN Serial Decode 355
Setup for LIN Signals 359
LIN Triggering 361
LIN Serial Decode 363
CAN/LIN triggering and serial decode requires Option AUTO or the
DSOX3AUTO upgrade.
Setup for CAN Signals
Setup consists of connecting the oscilloscope to a CAN signal, using the
Signals Menu to specify the signal source, threshold voltage level, baud
rate, and sample point.
To set up the oscilloscope to capture CAN signals, use the Signals softkey
which appears in the Serial Decode Menu:
1 Press [Label] to turn on labels.
2 Press [Serial].
3 Press the Serial softkey, turn the Entry knob to select the desired slot
(Serial 1 or Serial 2), and press the softkey again to enable decode.
4 Press the Mode softkey; then, select CAN trigger type.
5 Press the Signals softkey to open the CAN Signals Menu.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English