60 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
2 Horizontal Controls
• For setting up Pulse Width searches, see "Pulse Width Trigger" on
page 149.
• For setting up Rise/Fall Time searches, see "Rise/Fall Time
Trigger" on page 157.
• For setting up Runt searches, see "Runt Trigger" on page 160.
• For setting up Serial searches, see Chapter 10, “Triggers,” starting on
page 143 and "Searching Lister Data" on page 128.
Remember that searches use the measurement threshold settings instead
of trigger levels. Use the Thresholds softkey in the Search Menu to access
the Measurement Threshold Menu. See "Measurement Thresholds" on
page 237.
To copy search setups
Except for Serial event search setups, you can copy search setups to
trigger setups and vice- versa.
1 Press [Search].
2 In the Search Menu, press Search; then, turn the Entry knob to select
the search type.
3 Press Copy.
4 In the Search Copy Menu:
• Press Copy to Trigger to copy the setup for the selected search type to
the same trigger type. For example, if the current search type is
Pulse Width, pressing Copy to Trigger copies the search settings to the
Pulse Width trigger settings and selects the Pulse Width trigger.
• Press Copy from Trigger to copy the trigger setup for the selected search
type to the search setup.
• To undo a copy, press Undo Copy.
The softkeys in the Search Copy Menu may not be available when one
of the settings cannot be copied or there is no trigger type that
corresponds to the search type.
Navigating the Time Base
You can use the [Navigate] key and controls to navigate through:
To Next Page
Loading...
Need help?
General
