Agilent Technologies InfiniiVision 3000 X-Series User Manual

295
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
20
Utility Settings
I/O Interface Settings 295
Setting up the Oscilloscope's LAN Connection 296
File Explorer 299
Setting Oscilloscope Preferences 301
Setting the Oscilloscope's Clock 304
Setting the Rear Panel TRIG OUT Source 304
Performing Service Tasks 305
Configuring the [Quick Action] Key 311
Adding an Annotation 312
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface when a LAN/VGA module is installed in the rear panel
module slot.
• GPIB interface when a GPIB module is installed in the rear panel
module slot.
To configure the I/O interfaces:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press I/O.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English