284 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
18 Save/Recall (Setups, Screens, Data)
2 In the Save/Recall Menu, press Recall.
3 In the Recall Menu, press Recall:, then, turn the Entry knob to select
the type of file you want to recall:
• Setup (*.scp) — See "To recall setup files" on page 284.
• Mask (*.msk) — See "To recall mask files" on page 284.
• Reference Waveform data (*.h5) — See "To recall reference waveform files
from a USB storage device" on page 285.
• Arbitrary Waveform data (*.csv) — See "To recall arbitrary waveforms" on
page 285.
You can also recall setups and mask files by loading them using the File
Explorer. See "File Explorer" on page 299.
You can also configure the [Quick Action] key to recall setups, masks, or
reference waveforms. See "Configuring the [Quick Action] Key" on
page 311.
To recall setup files
Setup files can be recalled from one of 10 internal (\Agilent Flash)
locations or from an external USB storage device.
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select
Setup (*.scp).
2 Press the softkey in the second position and use the Entry knob to
navigate to the file to recall. See "To navigate storage locations" on
page 282.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display, press Clear Display.
To recall mask files
Mask files can be recalled from one of four internal (\Agilent Flash)
locations or from an external USB storage device.
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select
Mask (*.msk).
To Next Page
Loading...
Need help?
General
