Measurements 14
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 217
For more information on the types of measurements, see "Measurements
Summary" on page 217.
4 The Settings softkey will be available to make additional measurement
settings on some measurements.
5 Press the Add Measurement softkey or push the Entry knob to display the
measurement.
Cursors are turned on to show the portion of the waveform being
measured for the most recently added measurement (bottom- most on
the display). To view the cursors for a previously added measurement
(but not the last one), add the measurement again.
By default, measurement statistics are displayed. See "Measurement
Statistics" on page 239.
6 To turn off measurements, press the [Meas] key again.
Measurements are erased from the display.
7 To stop making one or more measurements, press the Clear Meas softkey
and choose the measurement to clear, or press Clear All.
After all measurements have been cleared, when [Meas] is pressed
again, the default measurements will be Frequency and Peak- Peak.
Measurements Summary
The automatic measurements provided by the oscilloscope are listed in the
following table. All measurements are available for analog channel
waveforms. All measurements except Counter are available for reference
waveforms and math waveforms other than FFT. A limited set of
measurements is available for math FFT waveforms and for digital channel
waveforms (as described in the following table).
To Next Page
Loading...
Need help?
General
