Agilent Technologies InfiniiVision 3000 X-Series User Manual

131
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
8
Display Settings
To adjust waveform intensity 131
To set or clear persistence 133
To clear the display 134
To select the grid type 134
To adjust the grid intensity 135
To freeze the display 135
To adjust waveform intensity
You can adjust the intensity of displayed waveforms to account for various
signal characteristics, such as fast time/div settings and low trigger rates.
Increasing the intensity lets you see the maximum amount of noise and
infrequently occurring events.
Reducing the intensity can expose more detail in complex signals as
shown in the following figures.
1 Press the [Intensity] key to illuminate it.
This key is located just below the Entry knob.
2 Turn the Entry knob to adjust the waveform instensity.
Waveform intensity adjustment affects analog channel waveforms only (not
math waveforms, referencewaveforms, digital waveforms, etc.).

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English