Agilent Technologies InfiniiVision 3000 X-Series User Manual

58 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
2 Horizontal Controls
Negative delay values indicate you're looking at a portion of the waveform
before the trigger event, and positive values indicate you're looking at the
waveform after the trigger event.
To change the time/div of the normal window, turn off Zoom; then, turn
the horizontal scale (sweep speed) knob.
For information about using zoom mode for measurements, refer to "To
isolate a pulse for Top measurement" on page 223 and "To isolate an event
for frequency measurement" on page 229.
To change the horizontal scale knob's coarse/fine adjustment setting
1 Push the horizontal scale knob (or press [Horiz] > Fine) to toggle between
fine and coarse adjustment of the horizontal scale.
When Fine is enabled, turning the horizontal scale knob changes the
time/div (displayed in the status line at the top of the display) in smaller
increments. The time/div remains fully calibrated when Fine is on.
When Fine is turned off, the Horizontal scale knob changes the time/div
setting in a 1- 2- 5 step sequence.
To position the time reference (left, center, right)
Time reference is the reference point on the display for delay time
(horizontal position).
1 Press [Horiz].
2 In the Horizontal Menu, press Time Ref; then, select:
• Left — the time reference is set to one major division from the left
edge of the display.
• Center — the time reference is set to the center of the display.
• Right — the time reference is set to one major division from the right
edge of the display.
A small hollow triangle (∇) at the top of the display grid marks the
position of the time reference. When delay time is set to zero, the trigger
point indicator (▼) overlays the time reference indicator.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English