Agilent Technologies InfiniiVision 3000 X-Series User Manual

259
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
17
Waveform Generator
To select generated waveform types and settings 259
To edit arbitrary waveforms 263
To output the waveform generator sync pulse 267
To specify the expected output load 267
To use waveform generator logic presets 268
To add noise to the waveform generator output 269
To add modulation to the waveform generator output 269
To restore waveform generator defaults 274
A waveform generator is built into the oscilloscope. It is enabled by
Option WGN or the DSOX3WAVEGEN upgrade. The waveform generator
gives you an easy way to provide input signals when testing circuitry with
the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope
setups. See Chapter 18, “Save/Recall (Setups, Screens, Data),” starting on
page 275.
To select generated waveform types and settings
1 To access the Waveform Generator Menu and enable or disable the
waveform generator output on the front panel Gen Out BNC, press the
[Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is
illuminated. When waveform generator output is disabled, the [Wave
Gen] key is off.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English