Agilent Technologies InfiniiVision 3000 X-Series User Manual

105
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
6
Digital Channels
To connect the digital probes to the device under test 105
Acquiring waveforms using the digital channels 109
To display digital channels using AutoScale 109
Interpreting the digital waveform display 110
To switch all digital channels on or off 112
To switch groups of channels on or off 112
To switch a single channel on or off 112
To change the displayed size of the digital channels 111
To reposition a digital channel 113
To change the logic threshold for digital channels 112
To display digital channels as a bus 114
Digital channel signal fidelity: Probe impedance and grounding 117
To replace digital probe leads 122
This chapter describes how to use the digital channels of a Mixed- Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX3000 X- Series models and
DSOX3000 X- Series models that have the MSO upgrade license installed.
To connect the digital probes to the device under test
1 If necessary, turn off the power supply to the device under test.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English