Alcatel-Lucent 7210 SAS M - Page 203

Virtual Leased Line Services
7210 SAS M Services Guide Page 203
Epipe Service Configuration Commands
• Epipe Global Commands on page 203
• Epipe SAP Configuration Commands on page 205
• Connection Profile Commands on page 209
• Show Commands on page 210
• Clear Commands on page 210
• Epipe Spoke SDP Configuration Commands on page 207
Note: Spoke SDP commands are not supported on 7210 SAS-M devices configured in Access Uplink mode.
Epipe Global Commands
config
—service
— [no] epipe service-id [customer customer-id] [create] [vpn vpn-id] [svc-sap-type { any | qinq-
inner-tag-preserve} ] (for 7210 SAS-M in Network mode)
— epipe service-id [customer customer-id] [create][vpn vpn-id] [svc-sap-type {null-star |
dot1q | dot1q-preserve|any| qinqinner-tag-preserve}](for 7210 SAS-M in Access uplink
mode)
—no epipe service-id
— description description-string
—no description
— [no] endpoint endpoint-name [create]
— active-hold-delay active-endpoint-delay
—no active-hold-delay
— revert-time [revert-time | infinite]
—no revert-time
— standby-signaling-master
— [no] standby-signaling-master
— sap sap-id [create]
—no sap sap-id
— service-mtu octets (for 7210 SAS-M in Network mode)
—no
service-mtu
—[no] service-mtu-check (for 7210 SAS-M in Network mode)