Alcatel-Lucent 7210 SAS M - Page 370

VPLS Services Command Reference
Page 370 7210 SAS M Services Guide
Clear Commands
—Clear Commands
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
clear
—service
— id service-id
— fdb {all | mac ieee-address | sap sap-id | mesh-sdp sdp-id[:vc-id] | spoke-sdp sdp-
id:vc-id}
— igmp-snooping
— port-db sap sap-id [group grp-address]
— querier
— statistics [all | sap sap-id | sdp sdp-id:vc-id]
— mesh-sdp sdp-id[:vc-id] ingress-vc-label
— spoke-sdp sdp-id:vc-id ingress-vc-label
— spoke-sdp sdp-id[:vc-id]
— stp
— detected-protocols [all | sap sap-id]
— statistics
— id service-id
— cem (applicable only for 7210 SAS-M in Network mode)
— counters
— mesh-sdp sdp-id
[:vc-id] {all | counters | stp }
— spoke-sdp sdp-id[:vc-id] {all | counters | stp | l2pt}
— stp
— sap sap-id {all | counters | stp }
— sdp sap-id {keep-alive}