Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1189
Sample Output
*A:ALA-12# show router 3 rip neighbor
==============================================================================
RIP Neighbors
==============================================================================
Interface Adm Opr Primary IP Send Recv Metric
Mode Mode In
------------------------------------------------------------------------------
router-2/1 Up Up 10.0.3.12 None Both 1
router-2/2 Up Up 10.0.5.12 BCast Both 1
router-2/3 Up Up 10.0.6.12 BCast Both 1
router-2/4 Up Up 10.0.10.12 BCast Both 1
router-2/5 Up Up 10.0.9.12 BCast Both 1
router-2/6 Up Up 10.0.17.12 None Both 1
router-2/7 Up Up 10.0.16.12 None Both 1
==============================================================================
*A:ALA-12#
Detailed Show RIP Neighbor Output — The following table describes the standard command
output fields for a RIP group.
Adm
Down — The RIP neighbor interface is administratively down.
Up — The RIP neighbor interface is administratively up.
Opr
Down — The RIP neighbor interface is operationally down.
Up — The RIP neighbor interface is operationally up.
Primary IP
The Primary IP address of the RIP neighbor interface.
Send Mode
Bcast — Specifies that RIPv2 formatted messages are sent to the
broadcast address.
Mcast — Specifies that RIPv2 formatted messages are sent to the
multicast address.
None — Specifies that no RIP messages are sent (i.e., silent
listener).
RIPv1 — Specifies that RIPv1 formatted messages are sent to the
broadcast address.
Recv Mode
Both — Specifies that RIP updates in either version 1 or version 2
format will be accepted.
None — Specifies that RIP updates will not be accepted.
RIPv1 — Specifies that RIP updates in version 1 format only will
be accepted.
RIPv2 — Specifies that RIP updates in version 2 format only will
be accepted.
Metric In
The metric added to routes received from a RIP neighbor.
Label Description
To Next Page
Loading...
