VPRN Service Configuration Commands
Page 1190 7750 SR OS Services Guide
Label Description
Neighbor
The RIP neighbor name.
Description
The RIP neighbor description. No Description Available indi-
cates no description is configured.
Primary IP
The RIP neighbor interface primary IP address.
Group
The RIP group name of the neighbor interface.
Admin State
Down — The RIP neighbor interface is administratively down.
Up — The RIP neighbor interface is administratively up.
Oper State
Down — The RIP neighbor interface is operationally down.
Up — The RIP neighbor interface is operationally up.
Send Mode
Bcast — Specifies that RIPv2 formatted messages are sent to the
broadcast address.
Mcast — Specifies that RIPv2 formatted messages are sent to the
multicast address.
None — Specifies that no RIP messages are sent (i.e., silent listener).
RIPv1 — Specifies that RIPv1 formatted messages are sent to the
broadcast address.
Recv Mode
Both — Specifies that RIP updates in either version 1 or version 2
format will be accepted.
None — Specifies that RIP updates will not be accepted.
RIPv1 — Specifies that RIP updates in version 1 format only will be
accepted.
RIPv2 — Specifies that RIP updates in version 2 format only will be
accepted.
Metric In
The metric value added to routes received from a RIP neighbor.
Metric Out
The value added to routes exported into RIP and advertised to RIP
neighbors.
Split Horizon
Disabled — Split horizon disabled for the neighbor.
Enabled — Split horizon and poison reverse enabled for the neigh-
bor.
Check Zero
Disabled — Checking of the mandatory zero fields in the RIPv1
and RIPv2 specifications are not checked allowing receipt of RIP mes-
sages even if mandatory zero fields are non-zero for the neighbor.
Enabled — checking of the mandatory zero fields in the RIPv1 and
RIPv2 specifications and rejecting non-compliant RIP messages is
enabled for the neighbor.
To Next Page
Loading...
