OAM and SAA Command Reference
7750 SR OS Services Guide Page 1433
If the interval is set to 1 second, and the timeout value is set to 10 seconds, then the maximum
time between message requests is 10 seconds and the minimum is 1 second. This depends upon
the receipt of a message reply corresponding to the outstanding message request.
Default 1
Values 1 — 10
next-hop ip-address — Only displays static routes with the specified next hop IP address.
Values ipv4-address: a.b.c.d (host bits must be 0)
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
interface interface-name — The name used to refer to the interface. The name must already exist in
the config>router>interface context.
bypass-routing — Specifies whether to send the ping request to a host on a directly attached network
bypassing the routing table.
count requests — Specifies the number of times to perform an OAM ping probe operation. Each
OAM echo message request must either timeout or receive a reply before the next message
request is sent.
Values 1 — 100000
Default 5
do-not-fragment — Sets the DF (Do Not Fragment) bit in the ICMP ping packet.
router router-instance — Specifies the router name or service ID.
Values router-name: Base , management
service-id: 1 — 2147483647
Default Base
timeout timeout — Overrides the default timeout value and is the amount of time that the router will
wait for a message reply after sending the message request. Upon the expiration of message
timeout, the requesting router assumes that the message response will not be received. Any
response received after the request times out will be silently discarded.
Default 5
Values 1 — 10
icmp-trace
Syntax icmp-trace [ip-address | dns-name] [ttl time-to-live] [wait milli-seconds] [tos type-of-ser-
vice] [source ip-address] [tos type-of-service] [router router-instance]
Context config>saa>test>type
Description This command configures an ICMP traceroute test.
To Next Page
Loading...
