OAM and SAA Command Reference
Page 1434 7750 SR OS Services Guide
Parameters ip-address — The far-end IP address to which to send the svc-ping request message in dotted decimal
notation.
Values ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
dns-name — The DNS name of the far-end device to which to send the svc-ping request message,
expressed as a character string to 63 characters maximum.
ttl time-to-live — The TTL value for the MPLS label, expressed as a decimal integer.
Values 1 — 255
wait milliseconds — The time in milliseconds to wait for a response to a probe, expressed as a
decimal integer.
Default 5000
Values 1 — 60000
tos type-of-service — Specifies the service type.
Values 0 — 255
source ip-address — Specifies the IP address to be used.
Values ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
router router-instance — Specifies the router name or service ID.
Values router-name: Base , management
service-id: 1 — 2147483647
Default Base
lsp-ping
Syntax lsp-ping {{[lsp-name] [path path-name]} | {prefix ip-prefix/mask}} [fc fc-name] [profile {in |
out}]] [size octets] [ttl label-ttl] [send-count send-count] [timeout timeout] [interval
interval] [path-destination ip-address] [interface if-name | next-hop ip-address]][detail]
Context oam>
config>saa>test>type
Description Performs in-band LSP connectivity tests.
The lsp-ping command performs an LSP ping using the protocol and data structures defined in the
RFC 4379, Detecting Multi-Protocol Label Switched (MPLS) Data Plane Failures.
The LSP ping operation is modeled after the IP ping utility which uses ICMP echo request and reply
packets to determine IP connectivity.
To Next Page
Loading...
