OAM and SAA Command Reference
7750 SR OS Services Guide Page 1457
policy-statement
Syntax policy-statement policy-name [...(up to 5 max)]
Context config>test-oam>ldp-treetrace>path-discovery
Description This command specifies policies to filter LDP imported address FECs.
Default no policy-statement
Parameters policy-name — Specifies the route policy name to filter LDP imported address FECs. Allowed values
are any string up to 32 characters long composed of printable, 7-bit ASCII characters. If the
string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes. The specified policy name(s) must already be defined.
retry-count
Syntax retry-count retry-count
Context config>oam-test>ldp-treetrace>path-discovery
config>oam-test>ldp-treetrace>path-probing
Description This command configures the path probing maximum number of failures.
Default 3
Parameters retry-count — Specifies the maximum number of consecutive timeouts allowed before failing a path
probe (ping).
Values 1 — 255
timeout
Syntax timeout timeout
no timeout
Context config>test-oam>ldp-treetrace>path-discovery
Description This command is used to override the default timeout value and is the amount of time that the router
will wait for a message reply after sending the message request. Upon the expiration of message
timeout, the requesting router assumes that the message response will not be received. Any response
received after the request times out will be silently discarded.
Default 30
Parameters timeout — Specifies the timeout parameter, in seconds, within a range of 1 to 60, expressed as a
decimal integer.
path-probing
To Next Page
Loading...
