Alcatel-Lucent 7750 SR OS - Page 151

Virtual Leased Line Services
7750 SR OS Services Guide Page 151
filter
Associates an IP filter policy or MAC filter policy with an egress SAP
or IP interface.
249
qos
Associates a Quality of Service (QoS) policy with an egress SAP or IP
interface.
251
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
252
queue
Specifies the ID of the queue whose parameters are to be overridden. 252
avg-frame-overhead
Configures the average frame overhead to define the average
percentage that the offered load to a queue will expand during the
frame encapsulation process before sending traffic on-the-wire.
254
adaptation-rule
Specifies attributes of the adaptation rule parameters. 253
cbs
Specifies attributes of the CBS parameters. 255
high-prio-only
Specifies attributes of the high-prio-only parameters. 256
mbs
Specifies attributes of the MBS parameters. 257
rate
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
258
scheduler-override
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
259
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
262
Configure Epipe SAP ingress parameters
config>service>epipe>sap#
ingress
Configures ingress SAP QoS policies and filter policies. 249
filter
Associates an IP filter policy or MAC filter policy with an ingress
SAP or IP interface.
249
match-qinq-dot1p
Configures filtering based on the p-bits in the top or bottom tag of a
Q-in-Q encapsulated Ethernet frame.
263
qos
Associates a Quality of Service (QoS) policy with an ingress SAP or
IP interface.
251
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
252
queue
Specifies the ID of the queue whose parameters are to be overridden. 252
adaptation-rule
Specifies the queue’s adaptation rule parameters. 253
cbs
Specifies the queue’s CBS parameters. 255
high-prio-only
Specifies the specified high-prio-only parameters. 256
mbs
Specifies the specified MBS parameters. 257
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page