Alcatel-Lucent 7750 SR OS - Page 156

Configuring a VLL Service with CLI
Page 156 7750 SR OS Services Guide
cbs
Specifies attributes of the CBS parameters. 255
high-prio-only
Specifies attributes of the high-prio-only parameters. 256
mbs
Specifies attributes of the MBS parameters. 257
rate
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
258
scheduler-policy
Applies an existing scheduler policy to an ingress or egress scheduler
used by SAP queues associated with a multi-service customer site.
262
multi-service-site
Creates a new customer site or edits an existing customer site with the
customer-site-name parameter.
246
no shutdown
Administratively enables the SAP. 233
Configure Fpipe spoke SDP parameters
config>service>fpipe# spoke-sdp sdp-id:vc-id [no-endpoint]
config>service>fpipe# spoke-sdp sdp-id:vc-id [endpoint endpoint-name] [icb]
egress
Configures the egress spoke SDP context. 271
ingress
Configures the ingress spoke SDP context. 271
filter
Associates an IP filter policy with an ingress or egress Service
Distribution Point (SDP).
271
vc-label
Configures the egress or ingress VC label. 272
precedence
Specifies the precedence of this SDP bind when there are multiple
SDP binds attached to one service endpoint.
128
no shutdown
Administratively enables the spoke SDP binding 233
Configure an Ipipe service
config>service# ipipe service-id [customer customer-id][vpn vpn-id] [vc-switching]
service-id
Specifies a unique service identification number identifying the
service in the service domain.
237
customer
Specifies the customer ID number to be associated with the service. 237
vpn vpn-id
Specifies the VPN ID number which allows you to identify virtual
private networks (VPNs) by a VPN identification number.
237
no shutdown
Administratively enables the service. 233
description
Specifies a text string describing the Ipipe service. 233
endpoint
Specifies a service endpoint. 238
Configure an Ipipe SAP
config>service>ipipe# sap sap-id
accounting-policy
Associates the accounting policy ID to the SAP. Accounting policies
are configured in the
config>log context.
248
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page