Programming Control
How
to
Program Cycle Modifier Heavy
Option "CnP4"
This option allows the owner to enable
or
disable the
Cycle Modifier Heavy Option.
1.
Press the DELICATESIBULKY (1\) or the
COLD
(v)
keypad to scroll through the
programmable Cycle Modifier options until
"CnP4" appears in the display.
2. When
"CnP4" appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Cycle Modifier Heavy Option value.
Refer to
Table
11.
3. Locate the desired number in the first column
of
Table
11.
4. Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
current number until correct.
NOTE:
To
go
back to the
current
programmable
option without changing the value, press the
WARM
«)
keypad.
5. Press the START (enter) keypad when the
desired number appears
in
the display.
The
next
Cycle Modifier option,
"CnP5", will appear in
the display.
NOTE:
To
program "CnP5" (Cycle Modifier
Added Wash Time), continue to next Cycle
Modifier option.
To
program other options, press
the WARM
«)
keypad and refer to the appropriate
section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
How
to
Program Cycle Modifier Added
Wash Time "CnP5"
This option allows the owner to set the amount
of
additional wash time for the Medium and Heavy Cycle
Modifier Options.
The
Extra Wash option needs to
be
turned
on
(refer to Cycle Modifier Medium and Heavy
options) for the Cycle Modifier Added Wash Time to
take effect.
1.
Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to scroll through the
programmable Cycle Modifier options until
"CnP5" appears
in
the display.
2. When
"CnP5" appears in the display, press the
START (enter) keypad. The current number
of
minutes set for the Cycle Modifier Added Wash
Time will appear in the display.
3.
Press the DELICATESIBULKY (1\) or the
COLD
(v)
keypad to increase or decrease the
current number
of
minutes shown in the display
to the desired number
of
minutes.
NOTE: The Cycle Modifier Added Wash Time can
be set from zero (0) to 15 minutes. The factory
default setting is
2.
4. Press the START (enter) keypad when the
desired number
of
minutes appears in
the
display.
The
next Cycle Modifier option, "CnP1"
(software version
"S
0
I")
or "CnP6" (software
version
"S
02" or higher), will appear in the
display.
NOTE:
For
software version
"S
01", to program
"droP"
(Drop
Off
Mode [on/om), press the WARM
«)
keypad
and
refer to option 28.
For
software
version
"S
02"
or
higher, to program "CnP6"
(Default Cycle Modifier), continue to next Cycle
Modifier option.
To
program other options, press
the WARM
«)
keypad and refer to the appropriate
section.
How
to
Exit Programming Feature
Press
the
WARM
«)
keypad until the control returns
to Ready Mode.
74
© Published by permission of
the
copyright owner -
DO
NOT
COPY
or TRANSMIT
802952
To Next Page
Loading...
