Programming Control
How to Program Default Cycle Modifier
"CnP6" (software version
"s 02"
or
higher
only)
This option allows the owner to set the Default Cycle
Modifier.
1.
Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad
to
scroll through the
programmable Cycle Modifier options until
"CnP6"
appears in the display.
2. When
"CnP6"
appears in the display, press the
START (enter) keypad. A number will appear
in
the display. This number corresponds to the
current default cycle modifier. Refer to
Table
12.
"CnP6"
Default Value
Cycle Modifier
0* Light
1 Medium
2
Heavy
*Factory default setting.
Table
12
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v) keypad to increase
or
decrease the
current number
to
the desired number selected
from
Table
12.
4. Press the START (enter) keypad
when
the
desired number
of
minutes appears in the display.
The next Cycle Modifier option,
"CnP1",
will
appear in the display.
NOTE:
To
program "PCt-" (Cycle Time Display),
press the WARM
«)
keypad
and
refer to
option
27.
To
program
other options, press the WARM
«)
keypad and refer to the appropriate section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to
Ready Mode.
802952
© Published by permission
of
the
copyright owner - DO NOT
COpy
or TRANSMIT
75
To Next Page
Loading...
