Programming Control
27. Cycle Time Display
"PCt·"
(software version "s 02"
or
higher only)
This option allows the owner to program the machine
to display a chosen cycle time in minutes instead
of
the calculated cycle time.
The cycle time display will not pause for fills
or
heating. The display will switch to
01
if
the breakaway
step is reached before the time display reaches 01.
If
the time displayed reaches
01
before the breakaway
step, the display will pause at
01
until the cycle ends.
How
to
Program Cycle Time Display
Enable "PCtE"
This option allows the owner to enable
or
disable the
Cycle Time Display.
1.
Control must be
in
Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad until "Prog" appears in
the
display. Press the START (enter) keypad and
"AtS1" will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until
"PCt-" appears in
the display. Press the START (enter) keypad and
"PCtE" will appear in the display.
4. When
"PCtE" appears in the display, press the
START (enter) keypad.
The
current Cycle Time
Display Enable status will appear in the display.
"on" = Option Enabled
"oFF" =Option Disabled (factory default
setting)
S.
Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the
desired status appears in the display.
7.
Press the START (enter) keypad with the last
active digit. The next Cycle Time Display option,
"PCt1
", will appear in the display.
NOTE:
To
program
"PCt1" (Cycle #1 Time),
continue to
next
Cycle
Time
Display option. To
program
other
options,
press
the
WARM
«)
keypad
and
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
How
to
Program Cycle
#1
Time "PCt1"
This option allows the owner to set the Cycle
#1
Time
display.
1.
Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through the
programmable Cycle Time Display options until
"PCt1" appears in the display.
2. When
"PCt1" appears in the display, press the
START (enter) keypad. The current Cycle
#1
Time is displayed.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase or decrease the
current number
of
minutes
to
the desired number
of
minutes.
NOTE:
The
Cycle
#1
Time
can
be
set from 0 to 255.
The
factory default setting is 34.
4. Press the START (enter) keypad when the
desired number
of
minutes appears in the display.
S.
The next Cycle Time Display option, "PCt2",
will appear in the display.
NOTE:
To
program
"PCt2" (Cycle #2 Time),
continue
to
next
Cycle Time Display option. To
program
other
options, press
the
WARM
«)
keypad
and
refer to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
76
© Published by permission
of
the copyright owner - DO NOT
COPY
or
TRANSMIT
802952
To Next Page
Loading...
