Programming Control
34.
IR
Access (On/Off)
"IrA"
This option allows the owner to enable
or
disable
allowing the control to
be
read
by
an external device.
How
to
Program the IR Access (On/Off)
1.
Control must
be
in
Manual Mode. Refer to
Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS1 " will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until "IrA" appears in the
display.
4. When "IrA" appears
in
the display, press the
START (enter) keypad. The current
IR
Access
status will appear
in
the display.
"on"
= Option Enabled
(factory default setting)
"oFF"
= Option Disabled
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, "rAEn", will appear
in
the display.
NOTE:
To
program
"rAEn"
(Manual
Rapid
Advance
[OnlOff),
refer
to option 35. To
program
other
options,
refer
to the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
35. Manual Rapid Advance (On/Off)
"rAEn"
This option allows the owner to enable
or
disable the
rapid advance feature. Refer to
Rapid Advance
Feature
section for more information.
How
to
Program the Manual Rapid
Advance (On/Off)
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS1" will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until "rAEn" appears in
the display.
4. When
"rAEn" appears
in the display, press the
START (enter) keypad.
The
current Manual
Rapid Advance status will appear
in the display.
"on"
= Option Enabled
(factory default setting)
"oFF"
= Option Disabled
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the
desired status appears
in the display. The next
option, "dAEn", will appear
in the display.
NOTE:
To
program
"dAEn"
(Manual
Diagnostics
[OnlOff]),
refer
to option 36. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
82
@ Published by permission
of
the copyright owner - DO NOT COPY
or
TRANSMIT
802952
To Next Page
Loading...
