Manual Reset
This feature allows the owner to reset the washer
control's programming data to the factory default
settings
by
pressing a sequence
of
pads on the control.
For an explanation
of
the Factory Default Settings,
refer to Default Washer Settings.
How
to Enter Manual Reset
1.
Control must
be
in Manual Mode to start.
Refer to Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until "rSEt" appears.
3. Press the START (enter) keypad.
The
control will
be
blank until the programming is complete.
Once the program has been reset, the control will
display the next Manual Mode option, "dIAg".
802952
© Published by permission
of
the copyright owner - DO
NOT
COPY
or
TRANSMIT
85
To Next Page
Loading...
