Collecting Audit Information
This feature allows the owner to retrieve audit
infonnation stored in the washer
by
pressing a sequence
of
pads on the control. For an explanation
of
the audit
options available, refer to
Table
14.
How
to
Enter
Audit
Feature
There are two methods
the
owner can use to enter the
Audit Feature.
Entering the Audit Feature
by
Manual
Mode
1.
Control must
be
in
Manual Mode to start. Refer
to Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until "AUdt" appears. Refer to
Figure 26.
CHM511R
Figure 26
3.
Press the START keypad. "CyC" will appear.
Entering the Audit Feature with the Coin
Vault Open
1.
Open coin vault.
Make
sure service door is
closed.
2. Press the START (enter) keypad.
How
to
Read
Audit
Data
1.
Use the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through various
options until the desired option is shown in the
display. Refer to the Audit Options List,
Table
14, for an explanation
of
the audit options
available.
Audit
Options
List
#
Display
Description
1
"CyC"
Total
#
of
machine cycles
2
"CoI1"
Total
#
of
coins
#1
3
"CoI2"
Total
#
of
coins
#2
4
"PLSE"
Total
#
of
Start Pulses
Table
14
2. Once the desired option appears in the display,
press the START (enter) keypad
once
to start the
audit count.
At
this point, the display will show
the
ftrst four-digit segment
of
the audit value.
If
the
audit count is 10,000
or
higher, press the
START (enter) keypad again to view the last four
digits
of
the
number.
NOTE:
The
display
can
show
up
to 4 digits
at
one
time.
Audit
counts
10,000
or
higher
are
separated
into
two
4-digit segments.
Each
time
the
START
(enter)
keypad
is
pressed
in
step
2,
the
display
will
show
the
next
4-digit
segment
in
the
audit
value.
If
the
value
is 9,999
or
less,
only
one
4-digit
segment
will
be
shown.
For Example:
In
the Total
Number
of
Coins # 1option
with "CoI1" shown in the display,
the
audit has
counted 10,009 coins. Pressing the START (enter)
keypad one time will show "
___
1" to represent ten
thousand. Pressing the START (enter) keypad a second
time will display "0009" meaning nine.
The
total
equals "00010009"
or
10,009.
3. Press the START (enter) keypad again.
The
control will
go
to the next audit option
in
the
Audit Options List.
4. To select other audit options, repeat steps 1 - 4.
How
to
Exit
Audit
Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
NOTE:
To
exit
Audit
Feature
when
using
Coin
Vault
Open
method,
owner
must
close coin
vault.
The
control
will
then
return
to
Ready
Mode.
84
@ Published
by
permission
of
the copyright owner - DO
NOT
COpy
or
TRANSMIT
802952
To Next Page
Loading...
