Programming Control
1.
Vend Price
#1
"AtS1"
This option allows the
owner
to set the
vend
price for a
nonnal/hot wash. This
vend
price will
be
shown
in
the
display when
NORMAL
and
HOT
are selected.
How
to
Program the Vend Price
#1
1.
Control
must
be
in
Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until
"Prog"
appears
in
the
display. Press
the
START (enter) keypad.
3.
"AtS1" will appear
in
the display. Press the
START (enter) keypad.
The
NORMAL
and
HOT
LEOs will
be
lit to
show
which cycle/temperature
price is being programmed.
4. There are five digits
in
the
Vend Price
#1.
The
fifth digit will appear
in
the
display
and
will flash
one
second on,
one
second off. Refer
to
Figure 3.
NOTE:
If
the vend price is $100.00
or
more, the
fifth digit is "1-6".
If
the vend price is $99.99
or
less,
the
fifth digit is
"0".
o
o
CHM507R
Figure 3
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad
to
increase
or
decrease the
value
of
the fifth digit.
NOTE: The vend price can be set from 0 to 65,535.
The factory default setting is 200.
6. Press the START (enter) keypad to enter the fifth
digit
and
display remaining four digits.
The
active digit will flash
one
second
on
and
one
second off.
NOTE:
To
go
back
to the current programmable
option without changing the value, press the
WARM
«)
keypad.
7. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
of
the active digit
and
the START (enter)
keypad
to
enter the value
of
the digit and advance
to
the next digit.
8. Press the START (enter) keypad with the last
active digit.
The
next
option, "dEn1", will
appear
in
the display.
NOTE:
To
program
"dEn1"
(Coin
#1
Value), refer
to
option 2.
To
program other options, refer to the
appropriate section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad
until the control returns
to Ready Mode.
24
© Published by permission of
the
copyright owner -
DO
NOT
COPY
or
TRANSMIT
802952
To Next Page
Loading...
