2.
Coin
#1
Value
"dEn1"
This option allows the owner to
set
a specific
numerical value for a
coin
entered.
For
example,
in
the
United
States the
coin
value for
one
quarter
would
be
measured
in
cents (25). Therefore,
the
coin
value
entered for
one
quarter
would
be
00025.
If
the
Vend
Price
#1 (option
1)
is
setfor".75",
and
the
Coin
Value is set for
"00025",
the
vend
price
displayed will decrease
by
.25 for
each
coin entered.
How
to
Program Coin
#1
Value
1.
Control
must
be
in
Manual Mode.
Refer
to
Entering the
Manual
Mode.
2. Press
the
DELICATESIBULKY
(A)
or
the
COLD
(v)
keypad until
"Prog"
appears
in
the
display. Press
the
START (enter)
keypad
and
"AtS1 " will appear
in
the display.
3. Press the DELICATESIBULKY
(A)
or
the
COLD
(v)
keypad
to scroll through the
programmable options until
"dEn1"
appears
in
the
display.
4.
When
"dEn1"
appears
in
the display,
press
the
START (enter) keypad.
There
are
five digits
in
the
Coin
#I Value.
The
fifth digit will
appear
in
the
display
and
will
flash
one
second
on,
one
second
off. Refer to Figure
4.
NOTE:
If
the
vend
price
is $100.00
or
more,
the
fifth digit is
"1-6".
If
the
vend
price
is $99.99
or
less,
the
fifth digit is
"0".
B
CHM507R
Figure 4
5.
Press
the
DELICATESIBULKY
(A)
or
the
COLD
(v)
keypad
to
increase
or
decrease
the
value
of
the
fifth digit.
NOTE:
The
coin value
can
be
set
from 1 to 65,535.
The
factory
default
setting is 25.
Programming Control
6. Press the START (enter)
keypad
to enter the fifth
digit
and
display remaining four digits.
The
active digit will flash
one
second
on
and
one
second off.
NOTE:
To go
back
to
the
current
programmable
option without changing
the
value, press
the
WARM
«)
keypad.
7. Press the DELICATES/BULKY (A)
or
the
COLD
(v)
keypad
to increase
or
decrease the
value
of
the active digit
and
the START (enter)
keypad to enter the
value
of
the digit
and
advance
to
the
next
digit.
8. Press the START (enter)
keypad
with
the last
active digit.
The
next
option,
"dEn2",
will
appear
in
the
display.
NOTE:
To
program
"dEn2"
(Coin #2 Value),
refer
to option 3.
To
program
other
options,
refer
to
the
appropriate
section.
How to Exit Programming Feature
Press
the
WARM
«)
keypad
until
the
control returns
to
Ready
Mode.
802952
©
Published
by
permission of the copyright owner -
DO
NOT
COPY
or
TRANSMIT
25
To Next Page
Loading...
