Programming Control
3.
Coin
#2
Value
"dEn2"
This option allows the owner to set a specific
numerical value for a coin entered when using the dual
coin drop. For example, the coin value for a dollar
coin would be measured in cents
(1.00). Therefore, the
coin value entered for one dollar coin would
be
00100.
If
the Vend Price
#1
(option 1) is set for
"2.00",
and
the Coin Value is set for
"00100",
the vend price
displayed will decrease by 1.00 for each dollar coin
entered.
How
to
Program Coin
#2
Value
1.
Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS
1"
will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through the
programmable options until
"dEn2"
appears in
the display.
4. When
"dEn2"
appears in the display, press the
START (enter) keypad. There are five digits in
the Coin
#2 Value. The fifth digit will appear in
the display and will flash one second
on
and one
second off. Refer to
Figure
5.
NOTE:
If
the
coin
value
is $100.00
or
more,
the
fifth digit is "1-6".
If
the
coin value is $99.99
or
less,
the
fifth digit is
"0".
B
CHM507R
Figure 5
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
of
the fifth digit.
NOTE:
The
coin
value
can
be
set
from
1
to
65,535.
The
factory
default
setting is 100.
6.
Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE:
To go
back
to
the
current
programmable
option
without
changing
the
value, press
the
WARM
«)
keypad.
7. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to increase or decrease the
value
of
the active digit and the START (enter)
keypad to enter the value
of
the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit. The next option,
"PLSE", will
appear in the display.
NOTE:
To
program
"PLSE"
(Start
Pulse Value),
refer
to
option 4. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
© Published by permission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
802952
26
To Next Page
Loading...
