Programming Control
9.
Audio Signal
"AUd"
This option allows the owner to program
when
the
signal will sound.
There
are five occasions
when
a signal
may
sound
during the washer operation.
These
five occasions are
listed below:
1.
End
of
Cycle Signal
By
default, the signal is turned off.
If
turned on,
the
signal will sound for three seconds
at
the
end
ofacyc1e.
2.
Keypad Depression Signal
By
default, this signal is turned
on
and will sound
for a quarter
of
a second. This signal will sound
each
time a keypad is pressed.
3. Coin
InputlCard
Insertion Signal
By
default, this signal is turned
on
and will sound
for a quarter
of
a second each time a coin
or
card
is entered.
4. Remove
Card
Signal
(Card
Models Only)
By
default, this signal is turned
on
and will sound
one
second
on
and
one
second
off
when the
control is prompting for card removal.
5.
Signal for Start
By
default, this signal is turned
on
and will sound
one
second
on
and
one second
off
for
10
seconds
after vend price has
been
satisfied.
How
to
Program the Audio Signal
I. Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press
the
DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until
"Prog"
appears
in
the
display. Press the START (enter) keypad and
"AtS1" will appear
in
the display.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through the
programmable options until
"AUd"
appears
in
the
display.
4.
When
"AUd"
appears
in
the display press the
START (enter) keypad. A number will appear
in
the
display. This number corresponds to the
current Audio Signal Programming Value.
5. Locate
the
desired number in the first column
of
Table 4 on the following page.
6. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
current number until correct.
For
Example: A user might wish to have the signal
sound only when a keypad is pressed. Entering the
number
"1"
in step 5 would turn
off
all the options
except KEYPAD.
In
this instance, the signal would
sound only when a keypad is pressed.
7. Press the START (enter) keypad
when
the correct
number appears
in
the display.
The
next option,
"CArd",
will appear
in
the display.
NOTE: To
program
"CArd"
(Card
Reader Display
Control), refer to option 10. To
program
other
options, refer to the
appropriate
section.
How
to
Exit Programming Feature
Press
the
WARM
«)
keypad until
the
control returns
to
Ready
Mode.
802952
© Published by permission
of
the copyright owner - DO NOT COPY
or
TRANSMIT
31
To Next Page
Loading...
