EasyManua.ls Logo

Alliance Laundry Systems FLW1526C - Page 71

Alliance Laundry Systems FLW1526C
255 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14.
Vend
Price #3 "AtS3"
This option allows the owner to set the vend price for a
normal/cold wash. This
vend
price will
be
shown
in
the display when NORMAL and COLD are selected.
How
to
Program the Vend Price #3
1.
Control must
be
in
Manual Mode. Refer to
Entering
the
Manual
Mode.
2. Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad until "Prog" appears
in
the
display. Press the START (enter) keypad and
"AtS1" will appear
in
the display.
3. Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to scroll through
the
programmable options until "AtS3" appears
in
the
display.
The
NORMAL
and
COLD
LEDs
will
be
lit to show which cycle/temperature price
is being programmed.
4.
When"
AtS3" appears
in
the display, press
the
START (enter) keypad. There
are
five digits
in
the
Vend Price #3.
The
fifth digit will appear
in
the display and will flash one second on,
one
second off. Refer to Figure 8.
NOTE:
If
the vend price
is
$100.00
or
more, the
fifth digit is "1-6".
If
the vend price is $99.99
or
less, the fifth digit is
"0".
a
CHM507R
Figure 8
5. Press
the
DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
of
the fifth digit.
Programming Control
NOTE: The vend price can be set from 0 to 65,535.
The factory default setting is 200.
6. Press the START (enter) keypad
to
enter the fifth
digit and display remaining four digits.
The
active digit will flash one second
on
and one
second off.
NOTE:
To
go
back to the current programmable
option without changing the value, press the
WARM
«) keypad.
7. Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
of
the active digit and the START (enter)
keypad to enter the value
of
the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, "AtS4", will appear
in the display.
NOTE:
To
program "AtS4" (Vend Price #4), refer
to
option 15.
To
program other options, refer to the
appropriate section.
How
to
Exit Programming Feature
Press
the
WARM «) keypad until the control returns
to Ready Mode.
802952 © Published by permission
of
the copyright owner - DO NOT
COPY
or
TRANSMIT
41

Table of Contents

Related product manuals