Programming Control
15. Vend Price #4 "AtS4"
This option allows the owner to set the vend price for a
perm press/hot wash. This vend price will be shown in
the display when PERM
PRESS and HOT are
selected
How
to
Program the Vend Price #4
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY (/\) or the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS1" will appear in the display.
3. Press the DELICATESIBULKY (/\)
or
the
COLD
(v)
keypad to scroll through the
programmable options until
"AtS4" appears in
the display. The PERM PRESS and HOT LEDs
will
be
lit to show which cycleltemperatore price
is being programmed.
4. When
"AtS4" appears in the display, press the
START (enter) keypad. There are five digits in
the Vend Price
#4. The fifth digit will appear
in
the display and will flash one second on, one
second off. Refer to
Figure
9.
NOTE:
If
the vend price
is
$100.00
or
more, the
fifth digit is "1-6".
If
the vend price is $99.99
or
less, the fifth digit is
"0".
B
CHMS07R
Figure 9
5. Press the DELICATESIBULKY (/\) or the
COLD
(v)
keypad to increase
or
decrease the
value
of
the fifth digit.
NOTE: The vend price can be set from 0 to 65,535.
The factory default setting
is
200.
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits.
The
active digit will flash one second on and one
second off.
NOTE:
To
go back to the current programmable
option without changing the value, press the
WARM
«)
keypad.
7. Press the DELICATESIBULKY (/\) or the
COLD
(v)
keypad to increase or decrease the
value
of
the active digit and the START (enter)
keypad to enter the value
of
the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit.
The
next option, "AtS5", will appear
in the display.
NOTE:
To
program "AtS5" (Vend Price #5), refer
to
option 16.
To
program other options, refer to the
appropriate section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
42
© Published
by
permission
of
the
copyright owner - DO NOT
COpy
or
TRANSMIT
802952
To Next Page
Loading...
